Invacare LiNX DLX-REM500 User Manual page 72

Invacare® LiNX
Driving Function Inhibits
• Drive lockout
Drive lockout (DLO) is a function to prevent the
wheelchair from being driven when the seat tilt or
recline are beyond a pre-determined safe total angle.
The total angle can be any combination of seat angle,
recline and/or surface angle. For most of the Invacare
wheelchair models, Drive lockout only responds when
you adjust angles in standstill. AVIVA RX makes an
exception: Drive lockout also responds while driving.
According to that, above icon is displayed in the status
bar. This indicator remains active until Drive lockout is
deactivated by adjusting seat angle and backrest angle.
72
Fig. 5-88
• Speed reduction
If the seat lifter or the seat angle has been adjusted
above a certain point, the drive electronics considerably
reduces the speed of the wheelchair. If speed reduction
has been activated, drive mode can only be used to
carry out movements in reduced speed and not for
regular driving. To drive normally, adjust the lifter or
the seat angle until the speed reduction is deactivated
again.
Speed reduction is shown in the display. If the seat
lifter or the seat angle is raised above a certain
point, the above icon is displayed in the status bar.
This indicator remains active until speed reduction is
deactivated again by lowering the lifter.
Fig. 5-89
1637425-I