Setting The Voice Mail (Vm) Tone Detection - Panasonic KX-TG2720S Operating Instructions Manual

*
For quick access to your voice mail box by using the right soft key (
the handset or (VM) on the base unit, you may add pauses between your
voice mail box access number and your mail box password in step 5.
Your voice mail box access number
Pressing (PAUSE/REDIAL) once creates a 3.5 seconds delay and counts as
one digit. The delay time depends on a telephone company.
Setting the Voice Mail ( VM ) Tone Detection
Your telephone company sends special signals (Voice mail tones) to activate
the VM indicator. Press
tone. If you hear a series of dial tones followed by a continuous dial tone, this
is indication that a new message was recorded. Your phone comes set to
detect these tones (set to "On"). Minutes after you hang up or after the phone
stops ringing, your unit will seize the phone line and check if a message has
been recorded. If a new message was recorded at your telephone company,
"Voice mail" will be displayed on the handset and the base unit VM
indicator will flash.
Set this programming to "Off" when:
—you do not subscribe to a voice mail service,
—your telephone company does not send a series of tones, followed by a
continuous tone, or
—your phone is connected to a business or office telephone system (PBX).
Please refer to below to set this programming to OFF.
If you are not sure which setting is required, consult your local telephone
company or contact Panasonic Customer Call Center.
Make sure the base unit and the handset are not being used.
1 Press
(CONF/FUNCTION)
"Initial setting" by pressing
and press
á
Scroll to "Voice mail" by pressing
2
, and press
Ñ
Press at "VM tone detect".
3
á
4 Press (Line 1) or
Ö
the line.
•The line's current setting will be displayed.
Select "Off" or "On" by pressing
5
and press the right soft key (
•A beep sounds.
•To exit the programming mode, press (OFF).
For assistance, please call: 1-800-211-PANA(7262)
EX. 1-222-333-4444 PPPP 8888
, or
, and scroll to
.
.
á
(Line 2) to select
Ñ
SAVE
Your mail box password
Pauses
(DIGITAL!SP-PHONE)
or ,
Ö Ñ
or
Ö
H
VM tone detect
G
or ,
Ö Ñ
VM tone detect
Line15678900:On
).
IH
LINE1 LINE2
MAIL ) on
to listen to the dial
---------------
VM tone detect
Save VM access#
F
=Line1 =Line2
S A V E
61