Table of Contents
Advertisement
PQQX14045ZA.book 34 ページ ２００４年２月１９日 木曜日 午後３時４７分
Voice Mail Service
Setting Voice Mail (VM) Tone Detection
Your telephone company sends special signals (Voice mail tones) to the unit.
Press [C] or [s] to listen to the dial tone. If you hear a series of dial tones followed
by a continuous dial tone, this indicates that a new message was recorded. Voice
Mail detection is preset at the factory to OFF. Minutes after you hang up or after the
phone stops ringing, your unit will seize the phone line and check if a message has
been recorded. If a new message was recorded at your telephone company,
"Voice Mail" will be displayed on the handset, and the Ringer/Message Alert
indicator on the handset will flash slowly if Message Alert is turned on (p. 17).
Leave this programming off when:
— you do not subscribe to a voice mail service,
— your telephone company does not send a series of tones, followed by a
continuous tone to indicate that you have new voice mail, or
— your phone is connected to a business or office telephone system (PBX).
See below to turn this setting on.
If you are not sure which setting is required, consult your local telephone company
or contact the Panasonic Customer Call Centre.
Press [MENU].
1
Scroll to "Initial setting" by pressing [d]
2
or [B], then press Select.
Press Select at "Voice Mail".
3
Scroll to "VM tone detect" by pressing [d]
4
or [B], then press Select.
Select "On" or "Off" by pressing [d] or [B].
5
6
Press Save, then press [OFF].
34
Handset
Initial setting
Back
Select
L
K
dB
Voice Mail
Back
Select
K
L
dB
VM tone detect
Back
Select
K
L
dB
VM tone detect
:Off
Back
Save
K
dB
L
Advertisement
Table of Contents
