Table of Contents
Advertisement
Voice Mail Service
To erase a stored number
Repeat steps 1 through 5 \ Press and hold
digits are erased \
•A beep sounds.
*
For quick access to your voice mail box by using
(FLASH/CALL!WAIT/VOICE!MAIL), you may add pauses between your voice
mail box access number and your mail box password in step 6.
Your voice mail box access number
Pressing (REDIAL/PAUSE) once creates a 3.5 seconds delay and counts as
one digit. The delay time depends on a telephone company.
Setting the Voice Mail (VM) Tone Detection
Your telephone company sends special signals (Voice mail tones) to
activate the VM indicator. Press
you hear a series of dial tones followed by a continuous dial tone, this is
indication that a new message was recorded. Your phone comes set to
detect these tones (set to "On"). Minutes after you hang up or after the
phone stops ringing, your unit will seize the phone line and check if a
message has been recorded. If a new message was recorded at your
telephone company, "Voice mail" will be displayed on the handset and
the base unit VM indicator will flash.
Set this programming to "Off" when:
—you do not subscribe to a voice mail service,
—your telephone company does not send a series of tones, followed by a
continuous tone, or
—your phone is connected to a business or office telephone system (PBX).
Please refer to below to set this programming to OFF.
If you are not sure which setting is required, consult your local telephone
company or contact Panasonic Customer Call Center.
Make sure the unit is not being used and the handset is lifted off the
base unit.
Press
1
(FUNCTION)
Scroll to "Program" by pressing
2
Press
3
á
44
(Next key) \
Ö
EX. 1-222-333-4444 PPPP 8888
.
.
(HOLD/CLEAR)
(Save key).
á
Your mail box password
Pauses
or
to listen to the dial tone. If
or
.
Ö
Ñ
until all of the
Ringer tone
HProgram
--------------
Advertisement
Table of Contents
