Setting Voice Mail (Vm) Tone Detection; Vm Tone Detect - Panasonic KX-TG2750S Operating Instructions Manual

Voice Mail Service
*To prevent misdialing, you may add pauses between your voice mail box access
number and your mail box password on page 45, in step 5.
Your voice mail box access number
Pressing [REDIAL/PAUSE] on the base unit or [PAUSE/REDIAL] on the
cordless handset once creates a 3.5 seconds delay and counts as one digit.
The delay time necessary between entering your access number and entering
your mail box password will depend on your telephone company.

Setting Voice Mail (VM) Tone Detection

(use either
Your telephone company sends special signals (Voice mail tones) to activate the
VM indicator. Lift the base unit handset, or press [DIGITAL SP-PHONE], [
[ ] to listen to the dial tone. If you hear a series of dial tones followed by a
continuous dial tone, this indicates that a new message was recorded. Voice Mail
detection is preset at the factory to ON. Minutes after you hang up or after the
phone stops ringing, your unit will seize the phone line and check if a message has
been recorded. If a new message was recorded at your telephone company, the
base unit VM indicator will flash and "Voice mail" will be displayed on the
cordless handset.
Set this programming to OFF when:
—you do not subscribe to a voice mail service,
—your telephone company does not send a series of tones, followed by a
continuous tone to indicate you have new voice mail, or
—your phone is connected to a business or office telephone system (PBX).
See below to turn this setting OFF.
If you are not sure which setting is required, consult your local telephone company
or contact the Panasonic Customer Call Center.
Base Unit
1
Press [FUNCTION/EDIT].
2
Scroll to "Initial setting" by pressing
[ ] or [ ], then press [ ].
3
Scroll to "Voice mail" by pressing [ ] or
[ ], then press [ ].
4
Press [ ] at "VM tone detect".
5
Select "Off" or "On" by pressing [ ] or [ ].
6
Press [ ] (Save), then press [EXIT].
Handset
Press [CONF/FUNCTION], and follow steps 2 to 5 above, using the
cordless handset. Press the soft key (
46
Ex. 1-222-333-4444 PPPP 8888
or
Base Unit
Pauses
)
Handset
), then press [OFF].
SA VE
Your mail box password
Initial setting
Voice mail

VM tone detect

VM tone detect
] or
:On