Setting The Voice Mail (Vm) Tone Detection - Panasonic KX-TG2267B Operating Instructions Manual

Voice Mail Service

Setting the Voice Mail (VM) Tone Detection

Your telephone company sends special signals (Voice mail tones) to
activate the VM indicator. Press
you hear a series of dial tones followed by a continuous dial tone, this is
indication that a new message was recorded. Your phone comes set to
detect these tones (set to "On"). Minutes after you hang up or after the
phone stops ringing, your unit will seize the phone line and check if a
message has been recorded. If a new message was recorded at your
telephone company, "Voice mail" will be displayed on the handset and
the base unit VM indicator will flash.
Set this programming to "Off" when:
—you do not subscribe to a voice mail service,
—your telephone company does not send a series of tones, followed by a
continuous tone, or
—your phone is connected to a business or office telephone system (PBX).
Please refer to below to set this programming to OFF.
If you are not sure which setting is required, consult your local telephone
company or contact Panasonic Customer Call Center.
Make sure the unit is not being used and the handset is lifted off the
base unit.
1 Press
(HOLD/FUNCTION/CLEAR)
Scroll to "Program" by pressing
2
and press
3 Scroll to "VM tone detect" by pressing
or
Ö Ñ
4 Press
á
5 Press
Ö
the line.
•The line's current setting will be displayed.
6 Select "Off" or "On" by pressing
Press
7
á
•A beep sounds.
•To program the other line, start again from step 3.
•To exit the programming mode, press (OFF).
•You can exit the programming mode any time by pressing (OFF).
46
.
á
.
.
(Line 1) or (Line 2) to select
Ñ
(Save key).
or to listen to the dial tone. If
.
or ,
Ö Ñ
or .
Ö Ñ
Save VM acces#
H
VM tone detect
Set line mode
VM tone detect
G F
=Line1 =Line2
VM tone detect
Line1:On
GF H
=Save
VM tone detect
Line1:Off