Trip; Functions Of Trip Meter - Hitachi ZAXIS 30U-5N Operator's Manual

Trip

Functions of Trip Meter

The trip meter allows the operator to know that the
machine operation hours has reached the preset hours by
blinking the Trip mark (Trip 1 or Trip 2). The Trip mark blinks
for 30 seconds when the machine operation hour reaches
the preset hours. After that, every time the key switch is
turned ON, the Trip meter blinks for 30 seconds until the
meter is reset.
IMPORTANT: This "Operation Hour" means the machine
operation time counted from the point at which
the Trip meter is set. It is different from the "Total
Accumulated Machine Operation Time" displayed on
the hour meter.
f
NOTE: Once the Trip meter is set, it will continuously count
the machine operation time regardless of the LCD display
status. When the machine operation hour reaches the preset
hours, the Trip mark on LCD display (1) blinks.
If Trip mark is displayed on the monitor screen when the Trip
mark starts blinking, the Trip mark stays ON after blinking.
If the Trip mark is not displayed on the monitor screen when
the Trip mark starts blinking, the Trop mark goes OFF after
blinking.
If the Trip mark is not used, set sufficiently long time.
(Example: 3000 h)
f
NOTE: The trip meter is set 9999.9h when the machine is
shipped from the factory.
OPERATOR'S STATION
1-37
Trip Mark
2
1
Trip Meter
MADH-01-036