Disconnect battery ground cable (−) before making
adjustments to electrical systems or before welding on
the machine.
Sufficiently illuminate the work site. Use a maintenance
work light when working under or inside the machine.
Always use a work light protected with a guard. In case
the light bulb is broken, spilled fuel, oil, antifreeze fluid,
or window washer fluid may catch fire.
When the floor tilt mechanism check and/or maintenance
is conducted, the operator's station is tilted upward.
Before conducting maintenance work, refer to page 13-
23 in this manual for the detailed operation procedures
and correctly operate the machine.
When required to work under the floor, support the
raised operator's station with the fall prevention bars (red
color) to ensure safety.
When the inspection/maintenance work is complete, tilt
the operator's station downward after housing the fall
prevention bars. Be sure to slowly lower the operator's
station at the time.
Be careful not to allow the operator's station to tilt down
without first stowing the fall prevention bars. Damage to
the tilt mechanism may result.
Warn Others of Service Work
Unexpected machine movement can cause serious injury.
Before performing any work on the machine, attach a "Do
Not Operate" tag in an easy-to-see place such as on the
cab door or control lever.
Never attempt to operate the machine with a "Do Not
Operate" tag attached.
Make it a rule for the inspection/service person to hold
the engine start key during inspection/service work.
SAFETY
S-24
SA-037
M1MW-07-031
SS2045102-4