Belt Tension Adjustment - Roland EGX-600 Service Notes

4-4 X BELT TENSION ADJUSTMENT (Referential Time : 10min.)
Remove the Rail Cover.
2
Loosen the Screw1 and 2 and then, loosen the Nut1 and 2.
2
Tighten up the Nut2 so that there is no gap between the
Frame and the Nut1.
It is possibe to adjust the X Belt Tension by
changing the position of the Nuts.
Push the X-Belt with the Tension Gauge (ST-001) at the
3
middle position between the X-Drive Pulley and check the
bending amount with the ruler.
Confirm that the Pressing Force matches with the Bending
Amount in reference to the next table.
Rail Cover
Nut1
Screw2
Frame
Nut2
ST-001
X Belt
<Reference Table>
Pressing Force Bending Amount
EGX-600 720gf
EGX-400 720gf
4 Adjustment
4
Screw1
10.0mm
7.0mm
75