Replacement Of Main Parts; Spindle Motor_Replacement - Roland EGX-600 Service Notes

3 Replacement of Main Parts

3 Replacement of Main Parts
Following table describes the necessary adjustment after the replacement of each parts.
Replacement Parts
X AXIS LM GUIDE
Y AXIS LM GUIDE
3
3-1 Spindle Moter_Replacement (Referential Time : 20 minutes)
Remove the Spoindle Cover.
1
Remove the Z Cable Cover, cut off the INSULOCK TIE and
2
disconnect the Spindle Motor Cable.
34
X MOTOR 1. X Axis Load Check
Y MOTOR 1. Y Axis Load Check
Z MOTOR 1. Z Axis Load Check
1. X Axis Load Check
1. Right Angle Adjustment of X Axis
2. Y Axis Load Check
1. X Belt Tension Adjustment
X BELT
2. X Axis Load Check
1. Right Angle Adjustment of X Axis
Y BELT
2. Y Belt Tension Adjustment
3. Y Axis Load Check
Necessary Adjustment
Spindle Cover
Spindle Motor Cable
Z Cable Cover