3-4 Z Axis Motor_Replacement (Referential Time : 30 minutes)
Remove the Spindle Cover.
1
Remove the Junction Board Cover.
2
Disconnect the Z Motor Cable, Z Limit Cable and Spindle
Motor Cable from the XZ Junction Board.
Remove the Limit SW and loosen the Spindle Cable Bush.
3
Then, cut off the INSULOCK TIEs and remove the Sponge.
Loosen the 4 screws on the Z Motor Base by rotating the Z
4
Screw and making the Z Slider up and down.
Spindle Cover
Sponge and
INSULOCK TIE
3 Replacement of Main Parts
3
Spindle
Motor
Cable
Spindle
Cable Bush
INSULOCK
TIEs
45