Appendix 3 Alert List - Furuno DS-60 Operator's Manual

APPENDIX 3 ALERT LIST

The table which follows shows the alert messages that can appear on the display, in the
[Alert I/F1], [Alert I/F2] and [Legacy] modes.
Note: The following features are NOT supported.
• Alert aggregation
• Functional alert grouping
• Responsibility transfer (The alert type of DS-60 is "Caution" only.)
• Alert Escalation (The alert type of DS-60 is "Caution" only.)
Legacy Mode
310 Echo Failure
Alert
Alert
description text
title
TCVR PS ERR
Lost
stopped speed
MEAS
MEAS.
Lost TCVR BV ERR
MEAS stopped speed
MEAS.
Lost
TCVR 5V ERR
MEAS
stopped speed
MEAS.
TCVR 12V ERR
Lost
stopped speed
MEAS
MEAS.
Missing ROT TEMP ERR
ROT stops 3-axis
speed.
ROT OPT ERR
Missing
stops 3-axis
ROT
speed.
ROT CTRL ERR
Missing
stops 3-axis
ROT
speed.
DISP COM ERR
Lost DISP
stops display
update.
Lost TCVR TCVR COM
ERR stops
speed MEAS.
Echo
RX echo ERR
Failure
reduces
reliability.
To access the [Alert Log] or [Active Alert List], see "How to display the Alert Log and Alert
List" on page 6-4.
AP-6
Alert I/F1 Mode
011 Echo Failure
Alert ID
Alert
Priority
category Legacy
Alert
I/F 1
Caution B 210 001
Caution B 211 002
Caution B 212 003
Caution B 213 004
Caution B 220 005
Caution B 221 006
Caution B 222 007
Caution B 231 008
Caution B 232 009
Caution B 310 011
Alert I/F2 Mode
3056
Meaning
Alert
I/F 2
Ship speed measurement stops
3009-1
because transceiver unit's transmis-
sion high voltage circuit is abnormal.
Ship speed measurement stops
3009-2 because transceiver's transmission
high voltage is outside specified range.
Ship speed measurement stops
3009-3
because transceiver's 5V voltage is
outside specified range.
Ship speed measurement stops
3009-4 because transceiver's 12V voltage is
outside specified range.
Ship speed measurement of "Bow"
and "Center" stops because
3119-1
temperature in ROT GYRO chassis
outside specified range.
Ship speed measurement of "Bow"
and "Center" stops because ROT
3119-2
GYRO optical system damaged
(Possible light source failure).
Ship speed measurement of "Bow"
3119-3
and "Center" stops because ROT
GYRO control damaged.
Display update stops because
3003-1
communication error with display unit.
Ship speed measurement stops
3003-2
because communication error with
transceiver unit.
The speed reliability is reduced
because the received echo is
3056
affected by bubbles and noise.
Echo Failure
Measures
Contact your
dealer.
Check if it depends on
draft or ship speed. If
this error recurs, contact
your dealer.