Furuno DS-60 Operator's Manual page 66

6. MAINTENANCE
2. Select [TESTS] then press the ENT key.
3. Select [System TEST].
4. Press the ENT key. The results of the display unit test appear.
STARTER PROG No. 6652000-xx.xx
BOOTER PROG No.
MAIN PROG No.
REMOTE PROG No.
DIMMER PROG No. 2651009-xx.xx
Description of test results for the Display Unit DS-600
• The results of the ROM and RAM check are shown as OK (normal) or NG (No
Good). For any NG, reset the power and try the test again. If the NG condition
continues, contact your dealer for instruction.
• "SENSOR" shows the results of the connection test with DS-610. OK for nor-
mal, no indication if there is error.
• "REMOTE" shows the results of the connection test with the Remote Controller
and Dimmer Controller. Operate the Remote Controller and Dimmer Controller.
OK appears if an operation is completed correctly. If the results location is
blank, there is no connection or there is no operation from the remote device.
• "LCD Time" shows how many hours the LCD has been on, up to a maximum of
999,999 hours.
• "BRILL" shows the current LCD brilliance setting. Press , . Check that the
indication and brilliance level agree.
• "+5V" shows the voltage of the +5.0V circuit.
6-6
-XXXX
OK
6652001-xx.xx
6652002-xx.xx
2651009-xx.xx