Furuno DS-60 Operator's Manual page 42

3. BERTHING DISPLAY
14. To save the line, press the MENU/ESC key to return to the [SET] dialog box (see
the figure at the top of page 3-10). Press  to show and select [Exit] then press
the ENT key. (The berthing line is sent to all active sub display units when the ENT
key is pressed.)
Note: If you select [Harbour View] without entering a name, the message "Har-
bour Name/Berthing Line plans must be named individually, please enter name."
appears. Enter a name.
15. To make another berthing line, repeat steps 4-14. To finish, press the DISP key.
Note: You can edit berthing lines. Open the [Berthing Line] menu, select [Edit] then
select a berthing line. The remaining procedure is similar to how you enter a berthing
line.
3-12