For [3 Way Split]:
Do the following:
1) Select [Point1] then press the ENT key.
2) Select the beam or channel to display
then press the ENT key.
3) Select the beam or channel for [Point2]
and [Point3] in the same method.
After you selected the beams or channels to
show for [Point3], the following screen ap-
pears.
4) Select [Start] then press the ENT key. The display now shows the echoes
from the beams (or channels) selected.
Echoes appear
here.
5) To change the range, press the RNG key. The available ranges are (in me-
ters) 5, 10, 20, 40, 100, 200 and 300. The current range is shown at the bot-
tom right corner on the echo monitor display.
6) To clear the echo data, press the DISP key.
Echoes appear
Echoes appear
here.
here.
6. MAINTENANCE
6-13