Furuno DS-60 Operator's Manual page 41

10. Select the [LON] line of [Point1] then press the ENT key.
11. Enter the longitude, same as how you entered the latitude.
12. Enter the points 2 and 3.
13. Select [Harbour View] then press the ENT key. The display shows
• Berthing line
• Name of berthing line, and
• Latitude and longitude position of each point.
Note: If the distance between two consecutive points is more than one degree,
the message "Points too far, maximum distance between points is 1 degree" ap-
pears. Reenter point(s).
Berthing line
Name of
berthing line
Position of
points
North Up
3. BERTHING DISPLAY
3-11