Toshiba Satellite 110 Series Maintenance Manual page 85

The following selections also appear at the bottom of the screen in succession:
(a) Drive number
Drive number select (1:#1,2:#2) ?
Select a drive number and press Enter.
(b) Interleave number
Interleave number (1/1 ~ 8) ?
Select an interleave number (1 ~ 8) and press Enter. Pressing only Enter
selects 1.
(c) Bad track register
The Bad Track register prompt appears as shown below. Enter the cylinder
and head numbers of bad tracks and press Enter. Note that if there are no
bad tracks, pressing Enter alone is the same as executing "All Track For-
mat" described in Item (d) below.
[ WARNING : Current DISK data will be
Press Bad cylinder number (dddd)] key ?
Press Bad head number (dd)] key ?
Enter the cylinder and head number in the format above in decimal notation.
Repeat for each bad track you want to format.
After entering the bad tracks, press Enter to execute the format.
(d) All track format
All tracks are formatted as good tracks except those registered as bad tracks
in Item (c) above or those identified as bad tracks in track verification
described in Item (d) below.
(e) Track verification
A check is made of all tracks and if an ECC error, ECC-correctable-data
error, or record-not-found error is detected at a track, that track is automati-
cally formatted as a bad track.
110 Series
completely destroyed ]
3-39