Toshiba Satellite 110 Series Maintenance Manual page 155

6. Lift the end of the reflector sheet covering the FL and lift out the FL. Be careful
not to pull or apply tension to the reflector sheet.
Figure 4-40 Removing the FL (110CS with DSTN)
Installing the FL
To install the FL, follow the steps below and refer to Figures 4-39 and 4-40.
1. Seat the FL, gently press it securely in place and cover it with the end of the
reflector sheet. Be careful not to pull or apply tension to the reflector sheet.
2. Secure two M2x6 screws.
3. Secure four latches.
4. Install the LCD module, FL inverter board, display mask, optional PC card,
optional memory module, and the battery pack as described in Sections 4.17,
4.15, 4.13, 4.4, 4.3, and 4.2.
110 Series
4-45