Figure 4-33 Removing the FL inverter board (110CS with DSTN)
Installing the FL Inverter Board
To install the FL inverter board, follow the steps below and refer to Figure 4-33.
1.
Connect the contrast control cable to PJ1 on the contrast control board.
2.
Seat the contrast control board. Be sure the wheel fits through the port.
3.
Secure the contrast control board with one M2.5x6 screw.
NOTE: Support the back of the display with your hand when you secure the
screws.
4.
Connect the FL inverter cable to CN1 and the FL cable to CN2 on the FL
inverter board.
5.
Seat the FL inverter board.
6.
Secure the FL inverter board with two M2.5x6 screws. Note the ground wire.
7.
Tape the FL cable down.
8.
Install the display mask, optional memory card, optional PC card, and battery
pack as described in 4.13, 4.4, 4.3, and 4.2.
110 Series
4-37