Toshiba Satellite 110 Series Maintenance Manual page 132

10. Release two latches at the back of the computer and lift up the top cover with
display assembly. Start above the ports on the left side and work to the right.
Figure 4-21 Removing the top cover with display assembly
Installing the RTC Battery and Top Cover with Display Assembly
To install the RTC battery and top cover with display assembly, follow the steps below and
refer to Figures 4-19 to 4-22.
1. Seat the top cover with display assembly from the front. Slowly rotate it to the
back, then secure the latches to the top cover.
2. Connect the LED panel cable to PJ14. Make sure the cable connection is
secured with the pressure plate.
3. Connect the panel close sensor cable to PJ10 (orange) on the system board.
CAUTION: Be sure to connect the panel close sensor cable to the orange
socket, not the white one. The white socket, PJ503, is for the sub-battery
cable. If these connectors are switched, the system will be damaged.
4. Secure the sub-battery base with one M2.5x8 screw.
5. Secure one M2.5x6 screw with ground cable and replace the tape.
4-22
110 Series