Toshiba Satellite 110 Series Maintenance Manual page 127

4.7 Sub-battery and VGA Board
Removing the Sub-battery and VGA Board
To remove the sub-battery and VGA board, follow the steps below and refer to Figures 4-15
to 4-17.
1. Turn the computer off. Disconnect the AC power cord and all external cables
connected to the computer.
2. Remove the battery pack, optional PC card, optional memory module, HDD, and
keyboard as described in Sections 4.2 through 4.6.
3. Disconnect the sub-battery from PJ503 and remove it.
WARNING: If you replace the sub-battery, be sure to use only batteries
recommended by Toshiba. Installation of the wrong battery can cause the
battery to explode or otherwise cause damage.
110 Series
Figure 4-15 Removing the sub-battery
4-17