Fujitsu Airstage J-IVS AJ 040LCLDH Series Design & Technical Manual page 790

Hide thumbs Also See for Airstage J-IVS AJ 040LCLDH Series:

Table of Contents

 Completion of setting mode

To exit the setting mode and return to the regular display, hold down the 3 buttons of SET TEMP.

", SET TEMP. "

If there is no key entry for 60 seconds, even though none of the above buttons is pressed, the set-

ting mode will be cleared automatically.

If the setting mode is automatically cleared during setting, you need to enter the setting mode again

by performing the procedure in

 Setting up each indoor unit

Setting must be performed on each indoor unit requiring address setting by repeating following pro-

"Preparation"

on page 07-39

"Entering setting mode"

"Indoor unit address setting"

"Refrigerant circuit address setting"

 Resetting the power after setting up all indoor units

• If the reset is not performed, function cannot be read correctly.

• After all the functions have been set, the circuit breaker needs to be switched off for at least 2

– After the 2 minutes has passed, power can be restored.

– The set function is stored in the PCB and will remain in memory even when the power of in-

door unit is turned off.

However setting function is effective after disconnecting the power supply and then recon-

• Record the latest configuration of the indoor unit function setting on a label, and put the label on

the unit so it can be used for after-sales service operations.

1-4. Address setting by remote controller

", and FAN at the same time for 5 seconds or longer.

"Entering setting mode"

on page 07-40

on page 07-41

on page 07-42

Simple remote

on page 07-40.

Simple remote

1. System settings

Chapters

Table of Contents