Fujitsu Airstage J-IVS AJ 040LCLDH Series Design & Technical Manual page 555

¢ Installation
• When the cable is attached to the wall:
– Remove the material covering the wiring penetration (thin material) in the cover of the sensor
unit with a pair of cutters. The cable passes through this hole.
– Attach the remote sensor unit on the wall using the screws.
– Fit the cover on the remote sensor unit and screw it in place.
• When the cable is buried in the wall:
– Remove the material (thinner than the surrounding material) in the wiring hole on the remote
sensor unit using a pair of cutters.
– Drill a hole in the wall for the cable.
– Seal the area around the cable penetration with putty.
– Fit the cover on the remote sensor unit and screw it in place.
¢ Specifications
Dimensions (H × W × D)
2-20. Remote sensor unit (UTY-XSZX)
Screw
(M4 × 16)
Screw
(M4 × 16)
mm
- (05-109) -
40
Mounting hole dimensions
20 20
ø6 to ø10
Mounting hole dimensions
70.2 × 55.2 × 18
Unit: mm
2. Control units