Base Stations; Base Stations Administration - Gigaset N670 IP PRO Installation, Configuration And Operation

Base stations

Base stations
This page is only to be used in the case that the device is used as master in a mini multi-
cell system.
The Integrator automatically recognises the base stations within the network. Base stations
need to be confirmed, activated and synchronised.

Base stations administration

The page allows you to assign base stations to the DECT managers.
It is only available in the Integrator user interface for the user role admin.
Use the following web configurator page to assign base stations to the DECT managers.
Settings Base stations
There are two tables:
•
Connected base stations lists all base stations which are already connected to the DECT
manager.
•
Pending base stations lists all base stations which are not yet connected to a DECT manager.
Connected base stations
The page shows the connected base stations with the following information:
MAC address Hardware address of the base station. With this address the device is uniquely
identified within the LAN.
Base station Name of the base station. When added to the list the MAC address is used as
name. The base station located at the same device as the DECT manager is
shown as LocalBS.
The name can be edited.
The symbol
RPN (Radio Fixed Part Number) Part of the RFPI. Identifies the base station on the
air interface. It also enumerates the base station within a DECT manager. Each
DECT manager gets a group of RPN to assign to its base stations. So it is
possible to identify the DECT manager the base station belongs to.
DM Name Name of DECT manager the base station belongs to.
The symbol
FW Version of the currently installed firmware.
The turning symbol
progress.
26
Administration
indicates that the base station function is disrupted.
indicates that the DECT manager is currently disconnected.
indicates that currently a firmware update is in