Operation Hints; Light Emitting Diodes (Led); Resetting The Base Station; Emergency Reset To Factory Settings - Gigaset N670 IP PRO Installation, Configuration And Operation

Operation hints

Operation hints

Light emitting diodes (LED)

The LEDs on the front side show different operational states. The LEDs can have three different
colours (red, blue, green) or can be off.
LED 1 (left)
0.5 s 0.5 s 0.5 s

Resetting the base station

You use the device button on the front side to reset the base station.
¤
Press the device button for at least 10 seconds until all LEDs switch off.
. . . the device is now in programming mode.
¤
Short press the device button until both LED lights blue.
¤
Press the device button at least three seconds but less than 10
seconds . . . the device is reset and rebooted.
The system is reset to factory setting. This means, that existing configuration and
user data will be lost.

Emergency reset to factory settings

When the device is booting
¤
Press the device button for at least 10 seconds until all LED switch off
. . . the device is now in programming mode.
¤
Press the device button until both LED lights blue
¤
Press the device button for at least four seconds . . . the device is reset and rebooted.
10
LED 2 (right)
0.5 s 0.5 s 0.5 s
Description
0.5 s 0.5 s
Power off
Device is booting
Firmware update in progress
No connection to LAN or
no IP address available/assigned
DECT ready
DECT traffic
DECT overload
Release the button
release the button