150
|
Maintaining and Transporting the Printer
Follow these steps to use maintenance mode:
1. Make sure the printer is turned off.
2. Press and hold the Pause button, then press the P Power button and
hold it until the printer turns on and the LCD displays
MAINTENANCE MODE.
3. Use the d and u buttons to select the settings described below. If you
need to back up to the previous menu level, press l.
To print a hex dump of data in the printer's buffer, press the
•
button to display
data in the left column and corresponding ASCII characters in the
right column. Press the Pause button to print the last page.
To change the language on the LCD display, press d to highlight
•
LANGUAGE
you want, then press
mode and returns to normal operation.
To enable the remaining paper counter, press d to highlight
•
REMAINING PPR SETUP
, then press
ROLL
To change the units of measurement, press d to highlight
•
then press
Menu
then press
To change the default cutting pressure, press d to highlight
•
, then press
PRESSURE
the pressure, or u to increase it (in 1% increments). Press
select the setting you want.
To run a super strong cleaning cycle, press d to highlight
•
SS CLEANING
start the cleaning cycle.
To enable roll paper feeding at power-on, press d to display
•
ON ROLL PPR FEED
setting you want, then press
To return all control panel settings to their default values, press d to
•
highlight
DEFAULT PANEL
Press
EXECUTE.
150
. Then press
PRINT
, then press
. Press d until you see the language
Menu
to select it. The printer exits maintenance
, then press
.
. Press d to switch from
to select it. Press
when done.
l
to display
Menu
, then press
to display
Menu
, then press
Menu
to save it.
, then press
to restore the default settings.
to print the 16-byte hex
. Press d to select
Menu
UNIT
to
METER
FEET/INCH
CUT
. Press d to decrease
100%
. Press
EXECUTE
PWR
. Press d to select the
to display
Menu
Menu
,
,
to
to