Table of Contents
Advertisement
IMPORTANT
• If the leading edge of the media is bent, cut the bent part before loading the media, as it may be difficult for the
media to enter the dryer entrance.
• If this does not work, start the media setup with the leading edge of the media at the entrance of the dryer.
This message appears when the length of opaque media is insufficient.
The media is not long enough to be detected. Raise the loading lever, prepare media that is 290 mm
(11.42 in.) or more in length, and then set up the media again.
[Loose Media Error]
Media may be caught and become loose at the entrance of the dryer.
Check which locations are causing the media to become loose and eliminate this problem.
Media may become loose because it has stuck to the inside of the dryer.
When you cancel the output, the temperature of the dryer cools. Check that the dryer has cooled down,
and then pull the media out from the top of the dryer while exercising caution regarding parts of the me-
dia that are not dry.
[Drain Bottle Error]
This message appears when the drain bottle has reached its limit for discharged fluid.
Discard the discharged fluid in the drain bottle, and then attach this bottle again.
MEMO
When the drain bottle is detached, the error message changes to [Install the drain bottle.].
This message appears when the drain bottle is misaligned.
Install the drain bottle again.
[Unable to Fill Wiper Cleaning Liquid]
The required cleaning cannot be performed because the cleaning liquid tank is empty and the wiper
tray cannot be refilled with cleaning liquid.
Refill the cleaning liquid tank with cleaning liquid.
[Print Head Height Mismatch]
The set print head height and the actual print head height are different.
Follow the instructions on the screen to change the print head height. When you change this height, [OK]
is displayed on the screen. Tap [OK] to resume printing.
If 10 minutes elapse after the print head carriage moves, this carriage is capped and the data is canceled
to prevent the heads from drying out.
RELATED LINKS
・
P. 118Changing the Print Head Height
Error Messages
Messages on the Operation Panel
231
Advertisement
Table of Contents
