Table of Contents
Advertisement
Error Messages
[Insufficient Media Width]
[The print data is larger than the media width. Continue output?]
This message appears when the size of the printing data is larger than the printing area of the loaded
media.
To continue performing output without making corrections, tap [Continue Output]. At this time, the por-
tion extending beyond the printing area is not output.
To cancel output, tap [Cancel]. Make the printing area wider, for example, by replacing the media with a
larger piece of media, and then send the data again.
[Crop marks cannot be added because the print data is larger than the media width. Continue output?]
This message appears when one of the following situations is detected.
• The size of the data with crop marks is larger than the printing area of the loaded media.
• The width of the printing data is less than 60 mm (2.36 in.).
To continue performing output without making corrections, tap [Continue Output]. The data is output
without printing the crop marks.
To cancel output, tap [Cancel]. Make the printing area wider, for example, by replacing the media with a
larger piece of media, and then send the data again.
The size of the data being output is too small.
Make the horizontal-direction (scan-direction) size of the data at least 60 mm (2.6 in.). To continue per-
forming output without making corrections, tap [Continue Output]. At this time, the data is output with-
out printing the crop marks.
To cancel output, tap [Cancel]. Increase the size of the data, and then send the data again.
[Ink Supply Error]
This message appears when no ink has been supplied.
Remove the relevant ink pouch tray and set the ink pouch again if sufficient ink remains in it. If only a
little ink remains, replace the ink pouch with a new one.
RELATED LINKS
・
P. 95Ink Pouch Replacement
[Temperature Increase Timeout Error]
A problem occurred while the temperature of the dryer was increasing and timeout occurred.
The dryer does not rise to the set temperature. Tap [OK] to reload the media.
[Motor Error]
A motor error occurred.
Operation cannot be continued. Turn off the sub power. Next, eliminate the cause of the error, then imme-
diately switch on the sub power.
If the machine is allowed to stand with the error uncorrected, the print heads may dry out and become
damaged. This error may be caused by such factors as a mistake in loading the media, a media jam, or an
operation that pulls the media with excessive force.
The media has jammed.
232
Messages on the Operation Panel
Advertisement
Table of Contents
