Hardware Option Cards; 10/100Base Ethernet Interface Card; Figure 15 10/100Base Ethernet Interface Card - Nortel 1010 Series Installing

38 Appendix A Technical specifications

Hardware option cards

The Contivity 1100 has two expansion slots that support a combination of the
following network interface cards:
•
•
•
•
•
•
•
•
This section provides information about the connectors and cable pinouts for each
supported interface card. For instructions on installing an option card, see
Chapter 2, "Installing option cards in the Contivity 1100," on page

10/100BASE Ethernet interface card

The 10/100BASE Ethernet interface card has a single RJ-45 connector that
provides the signals needed to interface to 10BASE-T and 100BASE-TX Ethernet
equipment.

Figure 15 10/100BASE Ethernet interface card

For information about the cables that you can connect to this interface and the
cable pinouts, see
314961-E Rev 00
10/100BASE Ethernet
56/64K CSU/DSU WAN
ADSL WAN
ISDN BRI
T1/E1 CSU/DSU WAN (half-height card)
T1 CSU/DSU WAN (full-height card)
V.90 modem
Single V.35/X.21 WAN
Figure 15 shows the 10/100BASE Ethernet interface card.
"10/100BASE Ethernet LAN ports" on page
29.
CS260009B
34.