Nortel 1010 Series Installing page 32

32 Chapter 2 Installing option cards in the Contivity 1100
11 Remove the blank card bracket (or the option card that you are replacing)
12 Install the new option card.
13 Carefully slide the chassis cover onto the base and secure it with the 4 screws.
14 Attach the bracket of the new option card to the front panel with 2 screws.
15 Connect the cables to the system ports and to the option card ports.
16 Plug the power cord into the AC power outlet.
17 Plug the external power supply into the port labeled "DC Input" on the back
18 Press the power switch to the "on" position and wait for the gateway to boot.
314961-E Rev 00
from the slot.
Caution: If you need to remove an ADSL option card from slot 3 (see
Figure 12 on page
slight angle, then carefully pull it up and out of the slot so that the card
clears the connector of the adjacent slot 2. If you damage components on
the underside of the ADSL interface card, the card will not work.
Caution: To prevent stress damage to components on the underside of
the ADSL option card when you install that card in slot 3 (see
on page 31), hold the card at a slight angle and insert it into the
connector so that the card clears the connector of the adjacent slot 2. If
you damage components on the underside of the ADSL interface card,
the card will not work.
Make sure to press the card all the way into the PCI connector on the
motherboard.
of the Contivity 1100.
Caution: The boot process can take as long as 3 minutes. Do not turn
the power off and on again; recycling the power quickly can cause
problems. Always wait at least 5 seconds after you turn off the power
before you turn it on again.
31), lift the free end of the card so that the card is at a
Figure 12