Nortel 1000 Hardware Installation Manual page 43

Figure 17 Removing/replacing the cover on the Application Gateway
Remove the 128 Mbyte DIMM boards from the Application Gateway.
2
Refer to Figure 18 on page
Remove all of the original 128 Mbyte DIMM boards.
Note
Grasp the ejector lever (A) on one end of the DIMM board and push
a.
down on the lever until the edge of the board connector (B) just lifts
out of the socket (C).
36.
CAUTION
Hold the tips of your fingers lightly on
the back edge (D) of the DIMM board to
prevent the board from suddenly
ejecting from the socket (C). The DIMM
board or other components on the
Application Gateway board could be
damaged if the DIMM board is allowed
to suddenly eject from the socket.
Application Gateway Administration Guide
Appendix A Upgrading Memory
Upgrading the Memory
553-AAA1108
35