Nortel 1000 Hardware Installation Manual page 30

Chapter 3 Hardware Installation and Initial Configuration
Connecting and Powering up the Application Gateway
3
22
Application Gateway Hardware Installation Guide
Connect Application Gateway Interface 1 (P2) to the server-side
-
network, directly or indirectly.
The P1 port (interface 0) is the bottom one of the two network interfaces
shown in Figure 11.
The P2 port (interface 1) is the top one of the two network interfaces shown
in Figure 11.
Figure 11 Back of Application Gateway
Power
P2
(Interface 1)
Connect a maintenance terminal to the Application Gateway.
Connect a DTE-DTE null modem serial cable (supplied with the
a.
Application Gateway) from the Serial Port on the back of the
Application Gateway to a maintenance terminal. The connection looks
like that shown in
Figure 12 Application Gateway connection to Terminal
Maintenance Terminal
P1
(Interface 0)
Figure 12 on page 22.
Serial Cable
Admin/Serial Port
Application Gateway
553-