Analyzer Messages; Enhanced Inverse Assembler Not Found; Inverse Assembler Not Found; Does Not Appear To Be An Inverse Assembler File - HP E2416B User Manual

Analyzer Messages

This section lists some of the messages that the analyzer displays
when it encounters a problem.

". . . Enhanced Inverse Assembler Not Found"

This error only occurs on the HP 16600/700 logic analysis systems. This error
occurs if you rename or delete the enhanced inverse assembler file that is
attached to the configuration file, or if you do not properly install the inverse
assembler file on the hard disk. Ensure that the inverse assembler file is not
renamed or deleted. If you use the File Manager Copy command to copy an
inverse assembler to the HP 16600/700 logic analysis systems, the enhanced
inverse assembler will not load. Use the Install procedures listed on the
jacket of the CD ROM to install the files for this product.

". . . Inverse Assembler Not Found"

This error occurs if you rename or delete the inverse assembler file that is
attached to the configuration file. Ensure that the inverse assembler file is
not renamed or deleted.
For the HP 16600/700 logic analysis systems, the inverse assembler must be
installed on the hard drive using the procedures listed on the jacket for the
CD ROM.
For other logic analyzers, if you have copied the files to the logic analyzer
hard disk, ensure that the inverse assembler is located in the same directory
as the configuration file.

". . . Does Not Appear to be an Inverse Assembler File"

This error occurs if the inverse assembler file requested by the configuration
file is not a valid inverse assembler. Use the Install procedures listed on the
jacket of the CD ROM to re-install the files for this product.
5–10 HP E2416B 80196 Analysis Probe