To Load Configuration And Inverse Assembler Files - Other Logic Analyzers - HP E2416B User Manual

Configuring
To load configuration and inverse assembler files — other logic analyzers
To load configuration and inverse assembler files —
other logic analyzers
If you have an HP 1660-series, HP 1670-series, or logic analyzer modules in
an HP 16500B/C mainframe use these procedures to load the configuration
file and inverse assembler.
The first time you set up the analysis probe, make a duplicate copy of the
master disk. For information on duplicating disks, refer to the reference
manual for your logic analyzer.
For logic analyzers that have a hard disk, you might want to create a
directory such as 80196 on the hard drive and copy the contents of the floppy
onto the hard drive. You can then use the hard drive for loading files.
Insert the floppy disk in the front disk drive of the logic analyzer.
1
Go to the Flexible Disk menu.
2
Configure the menu to load.
3
Use the knob to select the appropriate configuration file.
4
Choosing the correct configuration file depends on which analyzer you are
using. The configuration files are shown with the logic analyzer connection
tables, and are also in the table on the next page.
Select the appropriate analyzer on the menu. The HP 16500 logic
5
analyzer modules are shown in the Logic Analyzer Configuration
Files table.
Execute the load operation on the menu to load the file into the logic
6
analyzer.
The logic analyzer is configured for 80196 analysis by loading the appropriate
configuration file. Loading this file also automatically loads the inverse
assembler.
2–26 HP E2416B 80196 Analysis Probe