Spiked Bumper, Chain Catcher; Tools, Servicing Aids; Removing The Chain Catcher; Installing The Chain Catcher - Stihl MS 500i Service Manual

5

Spiked Bumper, Chain Catcher

5.1

Tools, Servicing Aids

Socket, T27x125 – 0812 542 2104 or equivalent
–
Torque wrench – 5910 890 0302 or equivalent
–
Screwdriver, T27x200 – 5910 890 2415 or equivalent
–
Open-end wrench, 8 mm
–
Loctite 242 (medium-strength threadlocking
–
adhesive) – 0786 111 2101
5.2

Removing the Chain Catcher

Preparations, @ 3.1.
N
Remove the chain sprocket cover.
N
Take out the screw (2).
N
Remove the chain catcher (1).
N
5.3

Installing the Chain Catcher

Fit the chain catcher (1).
N
If the original screw (4) is re-used: Coat thread of
N
screw (2) with Loctite 242.
Insert and tighten down the screw (2).
N
Fit the chain sprocket cover.
N
MS 500i
5
M5
4
3
1
5.4

Removing the Spiked Bumper

Preparations, @ 3.1.
N
Remove the chain catcher, @ 5.2.
N
Hold nut (5) steady and take out the screw (3).
N
Remove the spiked bumper (4).
N
5.5

Installing the Spiked Bumper

Place the spiked bumper (4) in position.
N
Insert the screw (3).
N
Hold the nut (5) steady and tighten down the
N
screw (5).
Install the chain catcher, @ 5.3.
N
Fit the chain sprocket cover.
N
M5x12 (8 Nm / 71 lbf. in.)
2
M5x16 (8 Nm / 71 lbf. in.)
5