16 Throttle Control
16.1
Tools, Servicing Aids
Pin punch, 5 mm
–
16.2
Removing Trigger Lockout, Throttle Trigger and
Throttle Linkage
Preparations, @ 3.1.
N
Remove the filter cover
N
Remove the air filter.
N
Remove the filter base, @ 15.2.
N
Remove the throttle body and sleeve, @ 15.4.
N
6
Hold the handle molding (1) steady.
N
Disengage the retaining lugs on the handle
N
molding (1).
MS 500i
2
1
3
4
6
1
5
Depress the lockout lever (6) and hold it in that
N
position.
Swing the handle molding (1) upwards, making sure
N
the lockout lever (6) and torsion spring (3) do not pop
out.
Remove the handle molding (1).
N
Swing the lockout lever (6) upwards and lift it away.
N
Pull the throttle linkage (2) out of the throttle trigger
N
(4).
Use a 5 mm pin punch to drive the pin (5) out of the
N
handle housing.
Take out the throttle lever (4) together with the torsion
N
spring (3).
Take the torsion spring (3) off the throttle trigger (4).
N
25