Filter Base, Throttle Body; Tools, Servicing Aids; Removing The Filter Base; Installing The Filter Base - Stihl MS 500i Service Manual

15 Filter Base, Throttle Body

1
3.5 Nm / 31 lbf. in.
2x
1
+
90°
2x
2
15.1

Tools, Servicing Aids

Socket, T27x125 – 0812 542 2104 or equivalent
–
Torque wrench – 5910 890 0302 or equivalent
–
Screwdriver, T27x200 – 5910 890 2415 or equivalent
–
15.2

Removing the Filter Base

Preparations, @ 3.1.
N
Remove the filter cover
N
Remove the air filter (1).
N
If the seal (2) is damaged: Remove the seal (2).
N
Take out the screws (3).
N
Remove the filter base (4).
N
15.3

Installing the Filter Base

Place the filter base (4) in position.
N
Insert and tighten down the screws (3).
N
Turn the screws (3) another 90°.
N
Push seal (2) onto flange of filter base (4) as far as
N
stop.
Fit the air filter (1).
N
Fit the filter cover.
N
If a new air filter (1) has been fitted: Calibrate the saw,
N
@ 4.
24
4
2
3
M5x22
(3,5 Nm /
31 lbf. in.)
5
6
7
The controller is optimally adjusted to suit the mechanical
components.
15.4

Removing the Throttle Body

Preparations, @ 3.1.
N
Remove the filter cover
N
Remove the filter base, @ 15.2.
N
Remove the throttle body (5) and disconnect it from
N
the throttle linkage (7).
Remove the sleeve (6).
N
15.5

Installing the Throttle Body

Fit the sleeve (6) in the manifold.
N
Connect throttle body (5) to throttle linkage (7) and
N
place it in position.
Install the filter base, @ 15.3.
N
Fit the filter cover.
N
Calibrate the saw, @ 4.
N
The controller is optimally adjusted to suit the mechanical
and mechatronic components.
MS 500i