Figure 5-3. System> Switch Status: Port Status - NETGEAR FS526T User Manual

The next part of the Switch Status page displays the port settings for both 10/100 Mbps and 10/100/1000 Mbps ports. To configure the ports, go to
the Switch> Port Configuration page.
ID:
o
Speed:
o
Flow Control:
o
QOS:
o
Link Status:
o
The port number on the switch
Indicates the communication mode set for the port. The default setting for all ports is Auto-negotiation (Auto).
The possible entries are Auto-negotiation (Auto), 10 Mbps half duplex (10M Half), 10 Mbps full duplex (10M Full),
100 Mbps half duplex (100M Half), 100 Mbps full duplex (100M Full), or Disable.
Indicates whether Flow Control support is set for on (Enabled) or off (Disabled). The default setting for all ports is
enabled.
Indicate the priority for the port. The default setting for all ports is Normal.
Quality of Service (QoS) is a way of managing traffic in a network, by treating different types of traffic with different
levels of service priority. Higher priority traffic gets faster treatment during times of switch congestion.
Indicates the current speed and duplex for the port. DOWN means no link.
Figure 5-3. System> Switch Status: Port Status
Page 24 of 58