Switch; Switch> Port Configuration; Figure 5-11. Switch> Port Configuration> Port Setting Menu - NETGEAR FS526T User Manual

Switch

There are 4 options available:
Port Configuration
o
Statistics
o
VLAN
o
Trunking
o
Switch> Port Configuration
Switch> Port Configuration: Port Setting menu
You can configure the status per port by clicking a port ID in the port setting menu.
ID:
o
Speed:
o
Flow Control:
o
QOS:
o
Link Status:
o
The port number on the switch. Click this number to configure the port.
Indicates the communication mode set for the port. The default setting for all ports is Auto-negotiation (Auto).
The possible entries are Auto-negotiation (Auto), 10 Mbps half duplex (10M Half), 10 Mbps full duplex (10M Full),
100 Mbps half duplex (100M Half), 100 Mbps full duplex (100M Full), or Disable.
Indicates whether Flow Control support is set for on (Enabled) or off (Disabled). The default setting for all ports is
enabled.
Indicate the priority for the port. The default setting for all ports is Normal.
Quality of Service (QoS) is a way of managing traffic in a network, by treating different types of traffic with different
levels of service priority. Higher priority traffic gets faster treatment during times of switch congestion.
Indicates the current speed and duplex for the port. DOWN means no link.
Figure 5-11. Switch> Port Configuration> Port Setting menu
Page 32 of 58