APPENDIX A: DEFAULT SETTINGS
This appendix provides default settings for the NETGEAR Model FS526T Smart Fast Ethernet Switch. You can always configure the switch to
default settings by using the Factory Reset function from a Web browser.
Table A-1. Default Settings
FEATURE
Port Speed
Port Duplex
Flow Control (half duplex)
Flow Control (full duplex)
IP Configuration
Default IP address (if no DHCP server)
Password
VLAN
Link Aggregation (Trunk)
Traffic Prioritization (QoS)
FS526T DEFAULT SETTING
Auto-negotiation
Auto-negotiation
Enabled
Enabled
DHCP enabled
192.168.0.239
password
Port-Based VLAN
Disabled
All ports set normal priority
Page 51 of 58