NETGEAR ProSafe FVS338 Reference Manual page 30

FVS338 ProSafe VPN Firewall 50 Reference Manual
Table 2-1. Internet connection methods
Connection Method
DHCP (Dynamic IP)
Fixed IP
3. Click Connection Status at the top right of the screen to verify your Broadband connection
status. Click Connect if connection not already present.
Figure 2-3
If Auto Detect does not find a connection, you will be prompted to check the physical
connection between your firewall and the cable or DSL line or to check your Router's MAC
address (see "Setting the Router's MAC Address (Advanced Options)" on page
4. Set up the traffic meter for ISP1 if desired. See
on page 2-12.
Note: At this point in the configuration process, you are now connected to the Internet
through the broadband Ethernet WAN. Optionally, you can continue with the
configuration of the dialup ISP serial WAN interface.
The Dialup Settings screen will assist you in setting up the router to access the Internet connection
using a dialup modem. Since the Dialup ISP Settings must be configured manually, you will need
all of your ISP settings information before you begin.
To configure the Dialup ISP serial WAN port:
2-4
Data Required
No data is required.
IP address and related data supplied by your ISP.
v1.0, September 2006
"Programming the Traffic Meter (if Desired)"
Connecting the FVS338 to the Internet
2-7).