CPS REPLACEMENT
1. Access the CPS harness from the right rear side of
the vehicle.
2. Disconnect the CPS harness connector.
3. Remove CPS retaining bolt
w
from the stator cover.
4. Install new sensor using a light coating of oil on the
O-ring to aid installation.
5. Torque CPS retaining bolt to specification.
TORQUE
CPS Retaining Bolt:
9 ft-lbs (12 Nm)
6. Reconnect CPS harness connector.
9929422 R02 - 2017-2019 ACE 900 Service Manual
© Copyright Polaris Industries Inc.
q
and remove the sensor
FUEL SYSTEM
4
4.35