Chapter 4. Module Connector; Module Connector Details; Module To Mounting Hardware; Figure 4-1. Jetson Tx2 Nx Module Installed In Sodimm Connector - Nvidia Jetson TX2 NX Manual

Table of Contents

Advertisement

Chapter 4. Module Connector

4.1

Module Connector Details

Jetson TX2 NX modules connect to the carrier board using a 260-pin SODIMM connector. The
mating connector used on the developer kit carrier board is listed in the Jetson TX2 NX
Supported Components List (SCL). This connector is a DDR4 SODIMM, 260-pin, right-angle,
standard key type. The full height of the connector is 9.2 mm. Refer to the connector
specification for details. Other heights are available.
4.2

Module to Mounting Hardware

The Jetson TX2 NX module is installed in the SODIMM connector which has latching
mechanisms to hold the board in place. In addition, it is required that the module is mounted
to the main carrier board PCB using metal standoffs and screws (or equivalent), both for
mechanical integrity and to provide additional grounding points. The developer kit uses
threaded standoffs that are hex, 4.5 mm widths (narrow diameter) x 6.57 ± 0.1 mm length.
These have M2.5 threads. The screws used are M2.5 x 3.7 mm, pan head.
Other SODIMM connector heights are available. If a different height connector is used, the
standoff height will have to be adjusted accordingly to account for the difference in height from
main PCB to module PCB.
Figure 4-1.
Jetson TX2 NX Module Installed in SODIMM Connector
Standoffs
Mounting
Screws
NVIDIA Jetson TX2 NX
SO-DIMM
Connector
Jetson TX2 NX
Module
(Envelope view)
DG-10141-001_v1.1 | 9

Advertisement

Table of Contents
loading

Table of Contents