Cleaning Infeed & Outfeed Rollers - Grizzly G0958 Owner's Manual

Table Height Chain & Sprockets
Oil Type ...................T26419 or NLGI#2 or Equiv.
Oil Amount ...........................................Light Coat
Frequency .......................................... As Needed
The table height leadscrews are synchronized by
the table height chain and sprockets (see Figure
41) located beneath the base of the machine. Lay
the machine on its back to access these compo-
nents. Use mineral spirits and shop rags to clean
away any debris and grime, then brush a light coat
of grease onto the chain and sprockets. Move
table up and down to distribute grease.
Sprockets
Table
Height
Chain
Figure 41. Location of table height chain and
sprockets.
-42-
Cleaning Infeed &
Outfeed Rollers
Saw dust and workpiece grime can accumulate
on the infeed and outfeed rollers, creating incon-
sistent pressure on the workpiece as it is fed
through the cutterhead.
Items Needed
Solvent ............................................................... 1
Shop Rags ......................................... As Needed
Carbide inserts are very sharp and can
quickly cut hands. ALWAYS use caution and
heavy leather gloves when working near
these parts to reduce risk of personal injury.
To clean infeed and outfeed rollers:
1.
DISCONNECT MACHINE FROM POWER!
2.
Lower planer table completely to expose
infeed and outfeed rollers (see Figure 42).
3.
Clean rubber infeed and outfeed rollers with
solvent to remove any pitch or stuck-on chips
(see Figure 42).
Figure 42. Cleaning infeed roller.
4.
Use a vacuum and clean brush to remove
any trapped material from between roller and
headstock.
Model G0958/G0959 (Mfd. Since 05/22)
Qty