Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
Eye injuries, respiratory problems, or hear-
ing loss can occur while operating this
tool. Wear personal protective equipment to
reduce your risk from these hazards.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G0958/G0959 (Mfd. Since 05/22)
manual
BEFORE
Typical Jointing Operation
1.
Examine workpiece to verify it is safe and
suitable for cutting.
2.
Adjust fence tilt, if necessary, and lock fence
in place.
3.
Adjust infeed table height to set depth of cut
per pass.
4.
Install dust port housing beneath outfeed
table and insert interlock keys in table slots.
5.
Put on safety glasses or face shield, a respi-
rator, and ear protection.
6.
Start jointer.
7.
Using push blocks as needed, hold workpiece
firmly against infeed table and fence, and
feed workpiece into cutterhead at a steady
and controlled rate until entire length of
workpiece has been cut, and it clears the
cutterhead on the outfeed table side.
8.
Repeat cutting process described above until
desired results are achieved.
9.
Stop jointer.
-25-
Advertisement
Table of Contents
