Inactive/Cold Replacement Workflow Of Memory - Fujitsu Oracle SPARC M12-2 Service Manual

Table 4-37 Inactive/Cold Replacement Procedure of the CMU (continued)
Work
Order
13
14
*1 If you replaced a CMU that uses the hardware RAID function, enable the hardware RAID function before
starting Oracle Solaris.
*2 If the replaced CMUU was in a SPARC M12-2S with no PCIe cards mounted, or if the CMUL was replaced, no
diagnosis is necessary (because diagnosis was performed in the previous step).
4.4.10

Inactive/Cold Replacement Workflow of Memory

You can perform inactive/cold replacement of memory in the following configuration:
Building block configuration where two or more physical partitions are operating
■
Before replacing the memory, see
in "7.1 Precautions for FRU
Table 4-38
Table 4-38 Inactive/Cold Replacement Procedure of Memory
Work
Order
1
2
3
4
5
6
7
Task
Switching the mode switch on the OPNL
to Locked, and powering on the physical
partition containing the SPARC M12-2S
that has undergone maintenance
Checking the operating condition of the
system
shows the workflow for inactive/cold replacement of memory.
Task
Checking the operating condition of the
system
Confirming the memory to be replaced
Checking the operation status of the
SPARC M12-2S that houses the memory
to be replaced
Powering off the physical partition
containing the SPARC M12-2S that
houses the memory requiring maintenance
Switching the mode switch on the OPNL
to Service
Releasing the SPARC M12-2S requiring
maintenance from the building block
configuration
Placing the SPARC M12-2S requiring
maintenance into the cold state, and
removing memory from the SPARC M12-2S
Reference
"10.8 Powering on a Physical
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical
"Precautions for CMU and memory
Replacement."
Reference
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical
"8.2 Troubleshooting"
"2.2.2 Checking Memory
"9.5.1 Stopping a Specific Physical
Partition"
"2.3.2 OPNL Control
"9.6.1 Releasing the SPARC M12-2S
From the Building Block
"17.4 Removing the CMU or
Chapter 4 FRU Replacement Workflows
Partition"
Domains"
replacement"
Domains"
Information"
Function"
Configuration"
Memory"
115