System-Stopped/Cold Replacement Workflow Of Memory - Fujitsu Oracle SPARC M12-2 Service Manual

Table 4-60 System-Stopped/Cold Replacement Procedure of the CMU (continue d)
Work
Order
5
6
7
8
9
10
11
12
13
14
*1 If you replaced a CMU that uses the hardware RAID function, enable the hardware RAID function before
starting Oracle Solaris.
4.6.10 System-Stopped/Cold Replacement Workflow of
Memory
Before replacing the memory, see
in "7.1 Precautions for FRU
Table 4-61
Table 4-61 System-Stopped/Cold Replacement Procedure of Memory
Work
Order
1
2
3
Task
Switching the mode switch on the OPNL
to Service
Removing the power cords of all the
SPARC M12-2/M12-2S units
Removing the CMU from the SPARC
M12-2/M12-2S
Installing the CMU in the SPARC M12-2/
M12-2S
Installing the power cords on all the
SPARC M12-2/M12-2S units
Diagnosing all the SPARC M12-2/M12-2S
units
Confirming that there is no problem with
the replacement CMU
Switching the mode switch on the OPNL
to Locked
Powering on the physical partitions (*1)
Checking the operating condition of the
system
shows the workflow for system-stopped/cold replacement of memory.
Task
Checking the operating condition of the
system
Confirming the memory to be replaced
Checking the operation status of the
SPARC M12-2/M12-2S that houses the
memory to be replaced
Reference
"2.3.2 OPNL Control
"9.8.2 Removing the Power
"17.4 Removing the CMU or
"17.5 Installing the CMU and
"10.1.1 Installing a Power
"10.5.1 Diagnosing the SPARC M12
Hardware"
"10.5.3 Checking the FRU Status After
Maintenance"
"2.3.2 OPNL Control
"10.9.1 Starting the System With an
XSCF Command"
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical
"Precautions for CMU and memory
Replacement."
Reference
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical
"8.2 Troubleshooting"
"2.2.2 Checking Memory
Chapter 4 FRU Replacement Workflows
Function"
Cords"
Memory"
Memory"
Cord"
Function"
Domains"
replacement"
Domains"
Information"
141