Active/Cold Replacement Workflow Of The Psu - Fujitsu Oracle SPARC M12-2 Service Manual

Table 4-9 Active/Cold Replacement Procedure of a PCIe Card (continued)
Work
Order
8
9
10
11
12
13
14
15
16
17
4.2.3

Active/Cold Replacement Workflow of the PSU

You can perform active/cold replacement of the PSU in the following configuration:
Configuration connecting two or more SPARC M12-2S units to a physical partition
■
Before replacing the PSU, see
for FRU
Table 4-10
Task
Removing the faulty PCIe card from the
SPARC M12-2S
Removing the faulty PCIe card from the
PCICS
Installing the replacement PCIe card in
the PCICS to install it in the SPARC
M12-2S or PCI expansion unit
Placing the SPARC M12-2S that required
maintenance into the hot state
Incorporating the SPARC M12-2S that
required maintenance into the building
block configuration
Diagnosing the SPARC M12-2S requiring
maintenance
Confirming that there is no problem with
the replacement PCIe card
Incorporating the SPARC M12-2S that
required maintenance into the physical
partition
Incorporating I/O resources of the SPARC
M12-2S requiring maintenance into a
logical domain
Checking the operating condition of the
system and the I/O device usage status
Replacement."
shows the workflow for active/cold replacement of the PSU.
Reference
"12.3.1 Enabling the Removal of a PCIe
Card"
"12.3.2 Removing a PCIe Card or PCIe
Card Filler"
"12.4.1 Installing a PCIe Card or PCIe
Card Filler"
"10.1.1 Installing a Power
"10.4.1 Incorporating the SPARC
M12-2S Into a Building Block
Configuration"
"10.5.1 Diagnosing the SPARC M12
Hardware"
"10.5.3 Checking the FRU Status After
Maintenance"
"10.6.1 Incorporating the SPARC
M12-2S Into the Physical Partition Using
PPAR DR"
"10.7 Incorporating I/O Resources Into a
Logical
"9.2 Checking the Operation Status and
Resource Usage Status of Oracle
"Precautions for PSU replacement" in
Chapter 4 FRU Replacement Workflows
Cord"
Domain"
Solaris"
"7.1 Precautions
79