Configuring The Faxfinder's Pots Modem - Multitech FaxFinder FF110 Quick Start Manual

Server Installation
g. From an ordinary POTS phone, dial one of the DID phone
numbers that is active in the system. Dial the DID phone
number as you would from an outside line (it will not work to dial
the number as if it were an ordinary 3- or 4-digit extension).
h. In the Current Status: DID Modem screen, the "State" field
should change to "Waiting for Connect." On the phone, you
should hear modem dialup/negotiation tones.
i. If you observe both the "Waiting for Connect" state and hear the
tones, then the FaxFinder's DID Modem has been configured
properly.
If either of these is absent, see item #3 "What if the modem
doesn't answer a call on the DID line?" in the "Troubleshooting"
section of the Administrator User Guide.

9. Configuring the FaxFinder's POTS Modem

The FaxFinder's POTS Modem directs outbound faxes sent by
clients into the public phone system. This POTS modem can also
receive faxes but that is a secondary function. All faxes coming in
on the POTS modem must go to the same email address to be
specified in the Phone Book screen.
a. In the FaxFinder Server software, go to the Modem
Configuration screen.
b. Under Modem Configuration: POTS Modem 2, enter the
settings with which you want to operate the FaxFinder's
outbound POTS modem. The default values have been
designed to work well in many situations.
Multi-Tech FaxFinder Quick Start
18