Multitech FaxFinder FF110 Quick Start Manual page 17

Multi-Tech FaxFinder Quick Start
b. Under Modem Configuration: Modem 1 (DID Modem), enter
the values that match the characteristics of your DID phone line
in the fields provided. (See the section "Prerequisite: Ordering
the DID Line" on page 7.)
c. Note that the value entered in the "Fax ID" field (typically the DID
phone number and, sometimes, an organizational identifier) will
appear in the fax log printed by the sender's fax machine.
d. Polarity. This refers to DID battery polarity. This parameter
must be set (and possibly re-set, as needed) on a trial-and-error
basis.
Signs of incorrect polarity:
(1) outside party originating call to DID number gets immediate-
busy signal after dialing;
(2) line suddenly disconnects just a call should go through.
e. Click Update.
f. Open the FaxFinder Server Home screen. Click on Current
Status. Watch the Current Status: DID Modem portion of the
screen. The "State" of the DID Modem (see Current Status:
DID Modem screen) should be "Waiting for Ring."
Server Installation
17